EI-OT ESP8266 4 Kanal PRO Relais Modul Zusammenbau und Bestückung
- EI-OT 4 Kanal PRO Relais Modulbausatz bestücken
- EI-OT 4 Kanal PRO Relais Platine mit 4 Kanal Relais Modul verbinden
Bestückung und Zusammenbau des EI-OT 4 Kanal PRO Relais
EI-OT 4 Channel PRO Relays Module assembling |
Zusammenbau / Bestückung
Das EI-OT ESP8266 4 Kanal PRO Relais Modul ist bereits mit SMD Komponenten bestückt. Zur Inbetriebnahme müssen nachfolgende Komponenten wie in nebenstehender Grafik (zum Vergrößern auf das Bild klicken) bestückt / verlötet werden Die Bestückung des EI-OT 4 Kanal PRO Relais Modul Schritt für Schritt:
Das EI-OT 4 Kanal Pro Relais ist fertig bestückt, sodass im nächsten Schritt die notwendige Verbindung zum Betrieb des 5V 4 Kanal Relais Modul hergestellt werden kann. |
Assembling
Besides the SMD components, the EI-OT 4 Channel PRO Relays Module requires additional components. Assembling of the 4 Channel PRO Relays Module Step by Step:
The basic assembling of the EI-OT 4 Channel PRO Relays Module is finished. |
EI-OT PCB 4 Channel PRO Relays Module 5V Power Supply |
Relais Modul 5V Spannungsversorgung
Um EI-OT PRO Relais Module mit Spannungen von 7-26V betreiben zu können, kann die Platine zusätzlich mit einem MP1584 5V Spannungskonverter bestückt werden. Wird das EI-OT 4 Kanal PRO Relais Modul mit 5V betrieben, so muss die Spannungsversorgung der Relais mittels einer Brücke hergestellt werden. Auf der Unterseite befinden sich hierzu 4 Pads
von der 2-poligen VCC Anschlussklemme auf die Eingangspannung der Relaisplatine, als auch den AMS1117 der Steuerungsplatine. |
Relays Module 5V Power Supply
In combination with a MP1584 5V Voltage Converter Module the EI-OT PRO Relais Module could be operated with 7-26V. If a MP1584 Module is assembled, the Output Voltage is directly connected to 5V Input of the EI-OT 4 Channel PRO relays Module. In case of EI-OT 4 Chanel PRO Relays Module is operated with 5V power supply 4 pads on bottom side must be connected
from the 2-pole VCC Screw connector to Relais Board and EI-OT 4 Channel PRO Controller Board. |
Assembling EI-OT PCB and Standard 4 Channel PRO Relays Module |
Relais Modul verbinden
Sobald die Platine fertig bestückt wurde, können Steuerungsplatine und das 4 Kanal PRO Relais Modul zusammengesetzt werden.
Das EI-OT 4 Kanal PRO Relais ist nun einsatzbereit. |
Relays Module Connection
Soon as the PCB is assembled, the controller PCB and the Relays Module can be assembled.
The EI-OT 4 Channel PRO Relays Module is finished. |